Design Rules for printed resistors on outer and inner layers 

1. Resistor length               L ≥ 1.5 mm
2. Resistor width                W ≥ 1.25 mm
3. Surrounding enlargement copper to resistor print
4. Overlap of the resistor print to copper
5. Height of the resistor     H 

The printed polymer resistor is calculated using the following formula: 

                 l
R = P x  ------
                 w

R ... resistance [Ω]
P ... paste value [Ω/□]
l  ... length [mm]
w ... width [mm] 

  
Here you have the opportunity of requesting our design rules for printed resistors on outer and inner layers.

Design Rules for printed resistors on outer layers
Design Rules for printed resistors on inner layers

Please note that these are standard design rules for printed resistors. 

However, we would also be pleased to look after the design details for your customized printed resistors.  Please complete the data in the following checklist as far as possible for your demand and send it to us by e-mail. We will get back to you without delay: 

Pull up / pull down resistor checklist - data specifications
 
Voltage divider checklist - data specifications
 
Power resistor checklist - data specifications